News:

Due to a technical issue, some recently uploaded pictures have been lost. We are investigating why this happened but the issue has been resolved so that future uploads should be safe.  You can also Modify your post (MORE...) and re-upload the pictures in your post.

Main Menu

Freeze Plug Diameter

Started by pauldridge, September 27, 2012, 08:34:33 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Tom Beaver

In the past the foundry used to in-bed wire in the sand molds to act as reinforcing bars.  After casting the block they would flush the sand out of the block cavity and usually removed the wire also, but not always.  I have seen this a time or two.  This is most likely what you see and you can just remove it and throw it away.

Tom Beaver

sjocad

I found it.
It was an old velding rod" there.May be lost when they took the dirt out.Now its ok.
Thanks folks... :-[
svein sjoblom,CLC # 12214.

1937 Lasalle opera coupe series 50.