Does anyone know how it's wired? Or know of a replacement one? I'm trying to check if it still works but I can't figure out how it's wired. I looked on the service manual and it shows there's 2 wires, a feed and a ground. But I can't find the locations...
Might not even work, I don't know. ..
The fan motor has two wires. One is grounded under the seat; the other runs under the carpet & behind the dash to the heater switch. It's on the same circuit as the defroster blower (mounted to top of left inner fender under the hood). Goes thru a 20 amp fuse. Does your defroster work?
The motor is shot. I pulled it out and tested it on the bench. It doesn't spin. Do you know if anyone makes a replacement?
I bought a replacement motor off eBay but it didn't fit. Wound up sending my old one to D&M restoration for a rebuild. dandmrestoration.com. They did a nice job- tested ok but I haven't installed it yet.
Do you know if it's a Clockwise or Counter Clockwise Rotation?
Quote from: Brett S
The motor is shot. I pulled it out and tested it on the bench. It doesn't
spin. Do you know if anyone makes a replacement?
Lots of motors can be recovered. If it draws no current, it
likely just needs a new brush job. If it draws a lot of current,
the bearings are likely locked. But those can be taken apart,
cleaned up, and oiled, and put back in service. I make sure
there are oil holes before putting a motor back.
good luck, Bruce Roe
Just checked mine. Rotation is CCW looking at the output shaft.
Thanks. I think I'll just replace the motor
When I got a replacement blower motor (made in Asia) it fit,
but did not have the power to do the work. I went to the yard
for a used one, now I might try to fix it. Bruce Roe