Author Topic: Kanter front end kit problem  (Read 1769 times)

Offline chris cunliffe

  • Posts: 111
Kanter front end kit problem
« on: April 10, 2011, 11:07:20 AM »
 Has anybody else had problems with the bushing seals in Kanters front end rebuilding kits?I rebuilt my 57 Seville front  suspension about 14 months ago and the car has been sat, unused, under cover since then.
Whilst fitting a new exhaust system a couple of weeks ago I was dismayed to see that the bushing seals appeared to have  perished and were all splitting.I contacted Kanter who are going to ship new seals but that would still leave me having to strip down the entire front end of the car again just to replace the seals.
 I have thought about splitting the seals and super- glueing them together around the bushings but dont know how successful this would be. Any thoughts ?

Chris
1957 Eldorado Seville #967

Offline Art Gardner CLC 23021

  • Posts: 1605
  • Name: Art Gardner
Re: Kanter front end kit problem
« Reply #1 on: April 15, 2011, 09:57:27 AM »
I have had similar problems, using seals from Steele.  It seems that the seals are not as tough as the original Cadillac parts.
Art Gardner


1955 S60 Fleetwood sedan (now under resto)
1955 S62 Coupe (future show car? 2/3 done)
1949 S60 Fleetwood sedan (restored 30+ yrs ago)
1958 Eldo Seville (2/3 done)

Offline 57flw

  • Posts: 364
  • From The Land Downunder
Re: Kanter front end kit problem
« Reply #2 on: April 15, 2011, 10:11:31 PM »
I got a Deluxe Front End Kit from Kanter for my 57 Fleetwood.

I did make a comment at the time that most of the parts had Made in America on them or at least on the packaging.

The tie rod ends, however, showed made in Taiwan.
The boots on these are already split on both sides and all I have done with the car so is push it around my shed.

Hope the rest of the gear from Kanter lasts longer.

Ken
Ken Francis
Hervey Bay
Queensland, Australia
1957 Series 60 Special Fleetwood
Skype: fleetwood1957

 

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13