All Cads

Author Topic: Throttle/Shift Linkage Grommet/Bushings  (Read 857 times)

Offline Jeff Wilk

  • J. Wilk CLC # 25630
  • Posts: 1324
  • The Past + The Future = My Heaven on Earth
  • Name: Jeff Wilk
Throttle/Shift Linkage Grommet/Bushings
« on: November 17, 2012, 08:37:16 PM »
I am in need of the rubber linkage bushings that have the metal sleeve in the middle.  On my '59 these are used in four places all part of the throttle/accelerator/shift/cruise control unit linkages.  USA Parts and Rubber The Right Way sell them but the inner metal sleeves are too small for the 1959 linkage.  I'd try to reuse my inner sleeves but only have three of the originals.  And besides, the rubber is all dried out anyway.  Any sources for these???

Jeff
"Impossible Only Describes The Degree Of Difficulty" 

Southern New Jersey

1959 Cadillac Fleetwood Sixty Special
1975 Eldorado Convertible (#12 made)
1976 Cadillac Mirage (factory authorized Pick-Up)
1933 Phaeton Chevrolet - "Baby Cadillac"
1933 Master Sedan Chevrolet - "Baby Cadillac"

SOLD
1958 Cadillac Sixty-Special
1958 Cadillac Sixty-Special
1958 Cadillac Sedan
1958 Cadillac Coupe Deville

Online bcroe

  • Posts: 3895
Throttle/Shift Linkage Grommet/Bushings
« Reply #1 on: November 17, 2012, 10:11:37 PM »
In some shift linkages, I have replaced these with aluminum shoulder
washers + flat washer.  Crude, but a permanent fix, I don't detect a
rattle.  good luck, Bruce Roe

Offline Grant Owen

  • Posts: 355
  • Name: Grant Owen
Re: Throttle/Shift Linkage Grommet/Bushings
« Reply #2 on: November 17, 2012, 11:27:48 PM »
Jeff, from memory the earlier model ones RTRW list for 41 - 55 part # 08-002X Have the bigger sleeves & they are a fraction of the price of the ones that don't fit. If they don't work just do what I have done in the past use a small bit of tubing with the correct ID & push it into the rubber bushing while pushing out the other sleeve.

 

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 


All Cads