1967 Lower Quarter Patch Panels

[Cadillac Nut]

I have searched high and low for patch panels for my 1967s lower quarters.  I have not found anyone who makes these.  My car has the lower portion of the driver's side quarter rusted out, bottom couple inches.  Passenger side is better but still needs a little work.   This is pretty common on '67s so I am surprised no one makes patch panels.  Anybody have any suggestions?  I cannot make them myself.   Anybody out there that could make them for me? 
Thanks,
Garrett

[Dan LeBlanc]

Too bad 66 isn't close enough to massage it to make it work.  I've seen 65-66 ones from USA Parts.

[Davidinhartford]

I bought front fender patch panels for my 74 Eldorado from a company called Autobody Specialties in Connecticut many years ago.

I just looked at their website and they don't list Cadillacs, but you could give them a call and see.

I can't imagine 74 Eldorados were more collectible then than 67-70 Eldorados are now.

[Cadillac Nut]

I too have see '65-66 quarters, it's too bad they don't work.  Wonder why those were made and not '67-68.  My car is a Fleetwood 75.  I will contact Autobody Specialties.  Worth a try.    I'd try making them myself but I don't have the tools. 

Thanks. 

[Barry M Wheeler #2189]

Why don't you try some of those "rust-free" people that advertise in HMN. 1967-68 Cadillacs should be identical, and perhaps even the same years in Olds 98 and Buick 225 Electras.

[Bob Hoffmann CLC#96]

I have searched high and low for patch panels for my 1967s lower quarters.  I have not found anyone who makes these.  My car has the lower portion of the driver's side quarter rusted out, bottom couple inches.  Passenger side is better but still needs a little work.   This is pretty common on '67s so I am surprised no one makes patch panels.  Anybody have any suggestions?  I cannot make them myself.   Anybody out there that could make them for me? 
Thanks,
Garrett

Are you looking for lower  quarter panel or front fender patch panels???
Bob

[Cadillac Nut]

Thanks.  Last time around I did try some of those people in HMN who advertised rust free parts.  They all wanted to sell me the entire quarter panel.   But I'll give it a shot again. 
Bob- It's lower quarter panel patch panels. 
Thanks again!