News:

Due to a technical issue, some recently uploaded pictures have been lost. We are investigating why this happened but the issue has been resolved so that future uploads should be safe.  You can also Modify your post (MORE...) and re-upload the pictures in your post.

Main Menu

1969 limo corner light rubbers out of shape ...

Started by 1969cadillac, October 21, 2018, 08:23:04 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

1969cadillac

hello - pls see pics attached of corner light rubbers

as you can see they are bent out of shape …

both bumper ends were NOT sitting squarely with body so this has caused the problem!

Q. is there any way to put them back in shape so that they FIT nicely??

your thoughts are appreciated , thx

Murray Mules

Mike Josephic CLC #3877

Nope -- there is no way to reshape those.  They
are made of polyurethane and I'm surprised that
they are still intact and not cracked.

Get replacements as they are being reproduced.
Try these folks -- good to deal with.
http://usapartssupply.com/

Mike
1955 Cadillac Eldorado
1973 Cadillac Eldorado
1995 Cadillac Seville
2004 Escalade
1997 GMC Suburban 4X4, 454 engine, 3/4 ton
custom built by Santa Fe in Evansville, IN
2011 Buick Lucerne CX
-------------------------------------
CLCMRC Museum Benefactor #38
Past: VP International Affiliates, Museum Board Director, President / Director Pittsburgh Region

harvey b

You could try a heat gun,warm them up a little and re install them?,at this point you have nothing to lose?not sure where you live,but if it is real hot outside i would set them in the sun for a couple of hours,might help,i would be gentle with them so they dont crack when you flex them. Good Luck  Harveyb
Harvey Bowness