Alternator Bracket

Started by Gearheadmike, September 20, 2018, 12:52:24 AM

Previous topic - Next topic

Gearheadmike

66 cad calais 429  po told me the guy before him gutted everything but the bare bones to run the engine. I pulled the alternator off to have tested and  belt alignment was off. I noticed the arm was tweaked and stack of washers and bottom bolt don't look right anyone have a pic of the top and bottom alt brackets so i can see if i'm missing anything. 
Mike

The Tassie Devil(le)

G'day Mike,

You have an email from myself that requires your attention.

Thanks,

Bruce. >:D
'72 Eldorado Convertible (LHD)
'70 Ranchero Squire (RHD)
'74 Chris Craft Gull Wing (SH)
'02 VX Series II Holden Commodore SS Sedan
(Past President Modified Chapter)

Past Cars of significance - to me
1935 Ford 3 Window Coupe
1936 Ford 5 Window Coupe
1937 Chevrolet Sports Coupe
1955 Chevrolet Convertible
1959 Ford Fairlane Ranch Wagon
1960 Cadillac CDV
1972 Cadillac Eldorado Coupe

TJ Hopland

One possible explanation is its not the correct alternator.   Many of the GM alternators over the years are very similar but not quite identical for mounting.   It could be something like someone put on a later higher amp unit that needed those washers to sort of fit. 

A 66 would have been the original GM externally regulated unit.   The 2 pin plug on those stuck out the back.  The internal regulated ones that came out around 73 had the connector sticking out side.     
StPaul/Mpls, MN USA

73 Eldo convert w/FiTech EFI
80 Eldo Diesel
90 CDV
And other assorted stuff I keep buying for some reason

Gearheadmike

This alt has the male plug that would go into it. Even tho the plug is no longer and there is just  2 spade connectors that were plug into it.
They removed all the s/c stuff so i'm not sure if that has anything to do with it.   
Now to fig why the gen light is on. battery and alt tested good.
Mike

TJ Hopland

Did a 66 have a smog pump?   In later years they aligned and arranged the belts so you could not just simply take the belt off the smog pump, if you did you would also loose something else that was kinda important.  Maybe spacer washers was a way to re align the belts without the smog pump if it had one?
StPaul/Mpls, MN USA

73 Eldo convert w/FiTech EFI
80 Eldo Diesel
90 CDV
And other assorted stuff I keep buying for some reason