Hydramatic bearing support screw

[Roman_cadillac]

Could someone provide dimensions and thread type of the bearing support locking srew?

free image upload

[Roger Zimmermann]

I may have that screw. I'll go to my store room in the next few days, if interested. Did you lost yours?

[Roman_cadillac]

I may have that screw. I'll go to my store room in the next few days, if interested. Did you lost yours?

yes, i lost it...  i ready buy this screw! 

i rebuilding hydramtic on 59 cadyy

sorry for my english)

[Roger Zimmermann]

OK, I'll look for it today, I hope I'll find it.
Where are you located?

[Roger Zimmermann]

I have it for $ 2.00 plus shipping (or 2 Euros if you are in that zone).

[Roman_cadillac]

I have it for $ 2.00 plus shipping (or 2 Euros if you are in that zone).

Nice! Ready to buy

Im from Russia. Can i pay it without paypal?

[Roger Zimmermann]

I'm sending a PM to you.

[Roger Zimmermann]

The bolt went today to Russia. I hope it will arrive...

[Chicken Coupe]

 Can the Hydramatic 315  1960  Be rebuilt at home without the special tools?

[Roger Zimmermann]

Yes and no. Most of the operations can be performed with regular tools and a bit of imagination. Snap ring pliers are a must, 3 are needed, but the cost from those tools is not excessive. One tool is needed: the one to remove the cover from the front unit coupling. This tool is not available but maybe you can find one. You can do your own with a thick steel plate.
 

[Chicken Coupe]

 I remember seeing one of your post Roger about the o-ring on the coupler.   The tool  you speak of is that 4 sided harmonic balancer puller looking thing?   Looks like an X bolts through each point ?

[Roger Zimmermann]

Yes. I'm adding a picture from the tool. The one on the right is also needed; easy to do if you have access to the needed material.

[Chicken Coupe]

Thank you Roger.

Roman Cadillac I am sorry I hijacked your thread.  Good luck with your project.